![]() For contractors working in the oil and gas industry, implementation of both systems is common practice. Some employers, however, have a site specific policy that requires both a guardrail fall protection system on the scaffold and the implementation of a PFAS. The PFAS is to be used where guardrails are not feasible, such as when guardrails are temporarily removed to load material onto the scaffold. It allows the use of either a guardrail fall protection system or a PFAS, with the guardrail fall protection system as the first choice. Section (vii) applies to the most supported scaffolds (frame, tube and coupler, system, wood pole, etc.). Only a PFAS is required on scaffolds listed in subpart (i), while subpart (ii), which applies to single-point and two-point suspended scaffolds, requires a guardrail fall protection system and a personal fall arrest system. (vii) For all scaffolds not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, each employee shall be protected by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section. (vi) Each employee performing overhand bricklaying operations from a supported scaffold shall be protected from falling from all open sides and ends of the scaffold (except at the side next to the wall being laid) by the use of a personal fall arrest system or guardrail system (with minimum 200 lb. toprail capacity) installed within 9.5” (24.1 cm) of and along at least one side of the walkway. (v) Each employee on a walkway located within a scaffold shall be protected by a guardrail system (with minimum 200 lb. (90.80 kg) toprail capacity) when the platform is supported by ropes (90.80 kg) toprail capacity) when the platform is supported by the frame structure, and by both a personal fall arrest system and a guardrail system (with minimum 200 lb. (iv) Each employee on a self-contained adjustable scaffold shall be protected by a guardrail system (with minimum 200 lb. (90.80 kg) toprail capacity), or by a three-fourth inch (1.9 cm) diameter grabline or equivalent handhold securely fastened beside each crawling board (iii) Each employee on a crawling board (chicken ladder) shall be protected by a personal fall arrest system, a guardrail system (with minimum 200-lb. (ii) Each employee on a single-point or two-point adjustable suspension scaffold shall be protected by both a personal fall arrest system and guardrail system (i) Each employee on a boatswains’ chair, catenary scaffold, float scaffold, needle beam scaffold, or ladder jack scaffold shall be protected by a personal fall arrest system Note to paragraph (g)(1): The fall protection requirements for employees installing suspension scaffold support systems on floors, roofs, and other elevated surfaces are set forth in subpart M of this part. Paragraph (g)(2) of this section addresses fall protection for scaffold erectors and dismantlers. Paragraphs (g) (1) (i) through (vii) of this section establish the types of fall protection to be provided to the employees on each type of scaffold. (3.1 m) above a lower level shall be protected from falling to that lower level. (1) Each employee on a scaffold more than 10 ft. The type of scaffold determines the system required by OSHA regulations, which are as follows: Fall protection systems on completed scaffolds are generally one of two systems-a guardrail fall protection system or a personal fall arrest system (PFAS). Points to consider include their varying types, utilized locations, strength of components, availability of personal fall arrest system anchorage points, and requirements on already completed versus to-be-erected scaffolds, to name a few. Determining the type of fall protection system used on scaffolds is complex for many reasons. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |